DDK - Die Deutschen Klassiker

Gary’s bread and butter
Saw this and was struck just how huge it was and also that it had suicide doors and only two of them.


Sent from my iPhone using Tapatalk

Good luck today
Hope it goes well

Are you able to take out an injector and put it in a container while you crank it to check you are getting fuel past the injectors?

This one!
I came in stealth mode in the Prius
I had been in the 911 all day as I went to the beach in it.
Shame to have missed you
Lots of noisy new cars there


Sent from my iPhone using Tapatalk

Today
Are you going?
Anyone else?

neilbardsley wrote: ↑Wed Apr 17, 2024 7:37 am https://youtu.be/qc7QnzwrnF0?si=s7YGGY4QCmDGRxDn

Sent from my 22011119UY using Tapatalk

Valentino Rossi interview about WEC

Same picture for me


Sent from my iPhone using Tapatalk

https://uploads.tapatalk-cdn.com/20240416/5b39394aebc7fd262b84a5a4eff69e27.jpg I took my distributor apart just to see how difficult it would be to lock it and use a cdi+ advance curve. This is not the one on the car but the one I hoped to use before I found that I could not get the insulated conne...

Maybe there is someone out there who fitted breakerless points and removed the insulated block?

I love your posts Mark.

It the bit circled above
For a 0 231 169 009 unit


Sent from my iPhone using Tapatalk

Does anyone have a spare gismo, low tension connection, for 73 911 distributor that has a spade connection on both the inside and outside of the distributor - the power for the points It should go through the hole in the side shown below https://uploads.tapatalk-cdn.com/20240412/627c56965589aacd6d2c...

Bootsy wrote: ↑Sat Apr 10, 2021 7:47 pm


Sent from my iPhone using Tapatalk

Raise a glass to Ian tonight

It has taken me a quite a while to get a photo of it but it is 0 231 184 001 which seems to a later version of the 169 008.168 009, 169 010 but with the points on the other side.
That is a very kind offer perhaps I could buy it off you if you have no use for it and you think it is ok?

I took off the cap and wiggled the rotor and the advance mechanism. There is some up and down movement and a bit of side to side movement in the shaft. However I think the advance mechanism was getting stuck and then releasing as having manipulated it all I got different advance readings particularl...